Power Outlet; Uconnect™ Phone - Chrysler 2010 300 User Manual

ELECTRONICS
NOTE: If you are having difficulty training your HomeLink
was manufactured after 1995, you may have a rolling code system. Follow the steps
for programming a rolling code system.
Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or "training"
button. This can usually be found where the hanging antenna wire is attached to
the garage door opener motor (it is NOT the button normally used to open and
close the door).
• Firmly press and release the "learn" or "training" button. The name and color of
the button may vary by manufacturer. Within 30 seconds, return to the vehicle and
press the programmed HomeLink
seconds each time). If the device is plugged in and activates, programming is
complete.
• If the device does not activate, press the button a third time (for two seconds) to
complete the training.
®
Using HomeLink
• To operate, simply press and release the programmed HomeLink
trained device will operate.
• Refer to your Owner's Manual on the DVD for further details. If you have any
problems programming HomeLink
1–800–355–3515, or on the Internet, at www.HomeLink.com.

POWER OUTLET

• There are two 12-volt electrical outlets on this vehicle.
• The outlet on the front console has power available only when the ignition is in the
ON position. If desired, this outlet can be converted by your authorized dealer to
provide power with the ignition switch in the LOCK position.
• The second outlet in the center console is powered directly from the battery
(power available at all times). Items plugged into this outlet may discharge the
battery and/or prevent engine starting.
NOTE: Do not exceed the maximum power of 160 Watts (13 Amps) at 12 Volts. If the
160 Watt (13 Amp) power rating is exceeded the fuse protecting the system will need
to be replaced.
uconnect™ phone
• The uconnect™ phone is a voice-activated, hands-free, in-vehicle communications
system.
• The uconnect™ phone allows you to dial a phone number with your cellular phone
using simple voice commands.
• Please refer to uconnect™ phone in the uconnect™ User's Manual on the DVD for
further details.
®
button twice (holding the button for two
®
, or require assistance, please call toll-free
32
®
and your garage door
®
button and the