Final Check - York Fitness Alliance Sensor GB0901584.3 Owner's Manual

only fold And moVe the treAdmill by following the "eAsy-lift fold up" And "moVing the treAdmill" instructions. do
not put the product on its side or try to lift the treAdmill. fAilure to follow this procedure mAy result in serious
injury due to pinch point AreA between the running geAr And the upright frAmes.
steP 4
Part C01 x 2
SCREW (M4 x 16MM)
Follow "Easy-lift Fold Up" and "Moving The Treadmill"
instructions to remove treadmill from the box.

final check

Your York alliance sensor treadmill is now assembled. Please make the following final checks:
• Make sure all screws / bolts are tightened.
• Make sure the equipment is on a flat, level surface.
Power uP
1. Plug one end of power cable into the treadmill as
shown.
2. Plug the other end into a suitable AC outlet (220-240
volt, 50Hz).
3. Switch the treadmill on using the on/off switch.
4. Attach the safety key to the console.
note: before you run on the treAdmill for the first time,
use the quicK stArt instruction And Allow the treAdmill
to run independently for 10 minutes. checK the running
mAt is tightened correctly And runs smoothly. if you
thinK the mAt needs Adjusting pleAse see neXt pAge for
more detAils.
10
aSSemBLy InStrUCtIonS
risk warning
C01 x 2
SAFETY SWITCH
ON/OFF SWITCH
POWER CORD