Center EHE0200153 User Manual page 10

Programming the EHE0200154
The temperature setting for period
d.
adjust this press the
button.
The next time and temperature period will now be active. Adjust this by repeating
e.
steps b - d above until all 4 periods are set for Monday or press the
run the program as set, at any time.
You now have a choice of how to set the program for the next day:
f. i) Press the COPY DAY button to copy Monday's program into Tuesday. The display
will go blank apart from the 'non flashing' day indicator, which indicates the day
copied and the 'flashing' target day to copy the program to. To accept this day
press the button. To select a different target day press the DAY button until the
'flashing' day indicator is under the required day, then accept it by pressing the
button. Note: Once the target day is confirmed it becomes the day that is copied if
the COPY DAY button is pressed again.
OR
ii) Press the DAY button to move the day indicator to Tuesday (Day 2). The program
for that day can then be adjusted by following steps b to e. Programs for the
remaining days can be set in the same way, using the DAY button to move to the
next day.
To exit the programming mode select the desired operating mode by pressing the
AUTO, MAN or OFF buttons. Note: To run the adjusted program select the AUTO
mode.
Disabling / Enabling Time Periods
The thermostat has 4 periods each day that can be programmed, but you may not
need all of these switch points for your heating requirements. Therefore, any period
from 2 to 4 can be removed from (or returned to) the heating program profile.
To disable or enable time periods:
a. To disable unwanted periods go to the desired period (
PROGRAM or
with the flashing square symbol. Press and hold the
and the display will indicate the period has been removed from the program.
b. To enable periods again follow the same procedure as above, navigating to the
already disabled period. To enable this period again press and hold the
at least 2 seconds.
on Monday (Day 1) will now be flashing. To
1
or buttons and confirm the setting again by pressing the
buttons to navigate, ensure the correct period is highlighted
10
button to
AUTO
to ) using the
2 4
button for at least 2 seconds
button for