Paitec MX-6000 User Manual page 12

8. Auto Start Button - You can choose to separate your job by using the 'Auto Start'
function. You can simply set your desired volume per run and the time interval in
between run. For example, if you set the counter at 50 and auto start at 5 seconds,
the machine will run 50 forms and stops for fi ve seconds until it starts again to process
50 forms and so on. (Available only when using batch counter function)
- Press the auto start button while the batch counter button is on.
- Change the time interval by using +/- button from 1 to 99.
- After the setting is ready, press the set button to store the setting.
9. Manual Feed Button - Allows the processing of single damaged forms.
- Press the manual feed button on the control panel.
- Place the folded form at the entrance of the outfeed on the conveyor.
- Then press the second manual button (red button located at the front cover).
10. Start/Stop Button - Start or stops the machine.
11. Reset Counter Button - Clears the count on the display panel.
12. Set Button - Stores any value or setting.
13. (+) Button - Increases the speed or value.
14. Total Counter - Displays the total count of the machine.
15. Counter - Displays the current count of the machine.
Important
- Please do not release the manual feed button on
the control panel until the job is completed.
- In case you release the manual feed button and
the panel reads 'stacker full', press the jam free
button to clear the form from the press rollers.
- 11 -
MX-6000 User Manual