Related Manuals for Paitec IM8100
Summary of Contents for Paitec IM8100
- Page 1 Sales • Service • Repair Professional Service – Fast Nationwide Shipping 1-866-455-9900 www.OnlineSkyline.com CustomerService@onlineskyline.com...
- Page 2 IM8100 Inline System User’s Manual <Rev. 111014/1>...
-
Page 3: Identifying Parts
This manual does not include all the contents about ES8000. Please refer to the user’s manual given. 1. Identifying parts ① Safety cover of feeding unit ② Safety cover of upper folding cassette ③ Control panel ④ Lower cassette cover ⑤... - Page 4 ① Paper tray ② Feed guide (left) ③ Feed guide (right) ④ Feed guide knob ⑤ Feed assist hanger ⑥ Feed roller assembly (Pick-up, feed, separate roller) ⑦ Control sensor for paper detection ⑧ Control sensor for tray height ① Lower cassette ②...
- Page 5 2. IM8100 Inline Parts <HP Printer Only Slide Mount Base> <Interface> <Interface Top Guide> <Interface fixing screw>...
-
Page 6: Control Panel
-Display: Displays the unit’s current status. ★ In order to use IM8100 as an Off-Line machine without the printer interface. please perform the following procedures to change the mode to an off-line mode. Make sure to remove "Interface and Interface Top Guide"... - Page 7 4. Interface unit installation and printer connection 1> Place the IM8100 rear feet onto the circular cut outs on the bracket. Optional Raiser 2> Turn on the power and set the unit in an offline mode by pressing on the mode button. Then open the safety cover of the feeding unit and the tray will go down.
- Page 8 4> Place the Interface onto the tray and tighten the screw. Interface fixing screw < > Interface < > 5> Connect the cable inside the feeder to the interface. 6> Change the mode to on-line and close the cover, which will make the tray to go down.
- Page 9 7> Open the cover and install the interface guide. When installing the top guides like the picture, make sure they are completely attached to the shaft of the machine. Push the top guide towards the bottom shaft until they are clicked and are properly fixed to the shaft.
- Page 10 11> Connect the network printer cable to your network cable. (Connect the USB cable from your computer directly to the printer if your printer is not in a network environment.) Please do not use a parallel cable. Tie the power cable and the cross cable and fix them to the surface of the product by using the clamp and the cable tie, like the picture below.
- Page 11 5. How to set the folding position. 1) Open the safety cover of the upper cassette and adjust the location of the stopper according to the folding position manual shown on the folding cassette...
- Page 12 2) Open the safety cover of the lower cassette and adjust the location of the stopper according to the folding position manual shown on the folding cassette.
- Page 13 6. How to operate in an off-line mode. 1) Remove the Interface Top Guides, Disconnect the cable connected to the interface. 2) Change mode into an off-line mode and open the safety cover, then the tray will go down. 3) Unscrew the screws and remove the interface. 4) Load the paper onto the tray.