Table of Contents
Advertisement
FLASH MODES
Autoflash with
red-eye reduction
Flash cancel
Fill flash
28
R
-
ECORDING
BASIC OPERATION
The flash can be used when taking still images. To
select the flash mode, press the up key of the
controller (1) on the back of the camera until the
desired mode is displayed. Press the shutter-
release button to set the mode. The active flash
mode is displayed in the top left corner of the LCD
monitor. When the camera is turned off and auto
reset (p. 45) is active, the flash mode is reset to
autoflash with red-eye reduction if this mode was
1
last used, if not the mode will be reset to autoflash.
While the flash is charging, the shutter cannot be
released.
Autoflash - the flash fires automatically in low-
Autoflash
light and backlit conditions.
Red-eye reduction - the flash fires multiple bursts
before the main flash burst to reduce red-eye; an
Fill-flash
effect caused by light reflected from the retina.
Use
photographs of people or animals, the pre-flashes
contract the pupils of the subject's eyes.
Fill flash - the flash fires with each exposure
regardless of the amount of ambient light. Fill flash
can be used to reduce harsh shadows caused by
strong direct light or sunshine.
Flash cancel - the flash will not fire. Use flash
cancel when flash photography is prohibited,
natural light is desired to illuminate the subject, or
the subject is beyond the flash range. The camera-
shake warning may appear when flash cancel is
selected (p. 22).
in
low-light
conditions
when
taking
Advertisement
Table of Contents
