Table of Contents
Advertisement
BASIC RECORDING OPERATION
Focus
Focus frame
signal
24
R
-
ECORDING
BASIC OPERATION
Slide the mode switch to the digital-subject-program or
recording position. The operation for both modes is the
same. Automatic Digital Subject Program Selection is only
active in the digital-subject-program mode.
Place the subject anywhere within the focus frame. Make
sure the subject is within the focus range of the lens (p. 26).
For very close subjects, use the Super Macro function (p.
30).
Press the shutter-release button partway down to lock the
focus and exposure. Automatic Digital Subject Selection will
choose the appropriate exposure mode, see the facing page.
The monitor focus signal is white and the focus frame turns
red to confirm focus lock. If the focus signal is red, the
camera was unable to locate the subject. Repeat the
previous steps.
Press the shutter-release button all the way down to take the
picture. The recorded image can be previewed by continuing
to hold down the shutter-release button after the image is
captured. The instant-playback function can also be used (p.
47).
The indicator lamp turns red and blinks indicating data is
being written to the memory card or internal memory. Never
remove or insert a memory card while data is being
transferred.
Advertisement
Table of Contents
