Advertisement
Troubleshooting:
Error Message
Problem
Device stabilization is in process.
Battery is low and no more measurements
are possible.
Measurement before device stabilization.
The device shows a rapid ambient
temperature change.
The ambient temperature is not within the
normal temperature range between 10
o
o
o
40
C (50
F ~104
F).
Error 5~9, the system is not functioning
properly.
Temperature taken is higher than 42.2
o
(108.0
F).
Temperature taken is lower than 34
o
(93.2
F).
Device can not be powered on to the ready
stage.
*Note: Suggest that the device is performed the re-test for accuracy after 3 years. Please send the complete
device to the dealers or nearest service address. However, if this device is used according to the
operation instruction, periodic re-calibration is not required.
Please read the instructions for use
Medical Technology Promedt Consulting GmbH
Add: Altenhofstrasse 80, D-66386 St. Ingbert, Germany
Radiant Innovation Inc.
Tel: +886 (3) 5644185 Fax: +886 (3) 5644170
E-mail:service@radiantek.com.tw
Add: 1F, No.3, Industrial East 9
th
Solution
Wait until
stops flashing.
Replace the battery.
Wait until
stops flashing.
Allow the thermometer to rest in a room for at
least 30 minutes at room temperature:
o
o
o
10
C and 40
C (50
F ~104
Allow the thermometer to rest in a room at least
o
C and
30 minutes at room temperature: 10
o
o
o
C (50
F ~104
F).
Unload the battery, wait for 1 minute and
repower it. If the message reappears, contact
the retailer for service.
o
C
Check the integrity of the probe cover and take a
new temperature measurement.
o
C
Make sure the probe cover is clean and take a
new temperature measurement.
Change with a new battery.
BF type applied part
Http://www.radiantek.com.tw
Road, Science-Based Industrial Park, HsinChu, Taiwan 300.
o
F).
o
C and 40
Ref No.：022010
Advertisement
