Specific Tooling - PIAGGIO 633234 Workshop Manual

X9 Evolution 500
the acid gravity is about 1.27, corresponding to 31
Bé and such values become steady.
- After charging, top up the acid (adding distilled
water). Close and clean carefully.
- After carrying out the operations above, install the
battery on the scooter, observing the connections
described in point 3) of paragraph "Battery re-
charge".

Specific tooling

020333Y Single battery charger
020334Y Multiple battery charger
1 Keep the pipe in vertical position
2 Inspect visually
3 The float must be freed
Checking the electrolyte level
The electrolyte level must be checked frequently and must reach the upper level. Only use distilled
water, to restore this level. If it is necessary to add water too frequently, check the vehicle's electrical
system: the battery works overcharged and is subject to quick wear.
Charging status check
After topping-up the electrolyte level, check its density using special density gauge.
When the battery is charged, you should detect a density of 30 to 32 Bé corresponding to a specific
weight of 1.26 to 1.28 at a temperature of no lower than 15° C.
A density reading of less than 20° Bé indicates that the battery is completely flat and it must therefore
be recharged.
If the scooter is not used for a given time (1 month or more) it will be necessary to periodically recharge
the battery.
The battery runs down completely in the course of three months. When refitting the battery onto the
scooter pay attention not to invert the cables, bearing in mind that the earth (black) wire marked with
a (-) must be connected to the negative terminal whilst the other two red wires, marked with a (+) must
be attached to the positive, + terminal.
Battery recharge
WARNING
BEFORE RECHARGING THE BATTERY, REMOVE THE PLUGS OF EACH CELL. KEEP SPARKS
AND NAKED FLAMES AWAY FROM THE BATTERY WHILE RECHARGING.
Remove the battery from the vehicle removing the negative clamp first.
Normal bench charging must be performed using the special battery charger (single) or (multiple), set-
ting the battery charge selector to the type of battery that requires recharging (i.e., at a current equal
Electrical system
ELE SYS - 77