Table of Contents
Advertisement
CPU Overheat LED: Pins 6 and 16
This connector connects to the CPU Overheat LED that lights up when
CPU temperature exceeds the CPU warning temperature set in the BIOS.
When this occurs, the system slows down until the temperature falls to a
safe level.
ATX Power ON Switch: Pins 7 and 17
This is an "ATX Power Supply On/Off Switch" that is
connected to the power switch on the case. When pressed for
more than 4 seconds, the system powers off. When pressed
for less than 4 seconds, the system enters the Suspend Mode
(depending on BIOS pre-settings).
Turbo LED Connector: Pins 8 and 18
There is no turbo/deturbo function on the motherboard. The
Turbo LED will always be On when linked to this connector.
Reset Switch: Pins 9 and 19
The reset switch allows the user to reset the system without
turning Off the main power and then On. Orientation is not
required when making a connection to this header.
Hard Disk Drive LED Connector: Pins 10 and 20
This connector connects to the hard drive activity LED on
the control panel. The LED flashes when HDD is in use.
TI5VGA Socket 7 MVP3 ATX Motherboard User's Manual
Chapter 5 Installation
J21 Pin #
Signal Name
6
5V
16
Ground
J21 Pin #
Signal Name
8
5V
18
Ground
J21 Pin #
Signal Name
10
Ground
20
5V
31
Advertisement
Table of Contents
