Trane 18-HD64D1-4 Installation Manual page 5

3.3
Mounting Sub-Base to Wall
Be sure wires are routed through the center of the
base plate and are long enough to connect to ter-
minals.
Select and mark three holes.
NOTE: The three hole locations indicated at right
are recommended. The top location is an optional
mounting screw location.
A level may be used to ensure professional appear-
ance.
3.4
Mounting to Studs
Attach base to wall using 3 screws provided. The
locations indicated provide the most secure mount-
ing and are recommended.
NOTE: Since moderate force is required when re-
moving the Control from the sub-base, the sub-base
must be securely attached to the wall.
Do not overtighten screws to avoid damaging the
sub-base.
3.5
Mounting to Drywall
If mounting to drywall, supplied SnapSkru
These anchors will ensure that the Control is adequately supported.
NOTE: Since moderate force is required when removing the Control from the sub-base, a firmly mounted
sub-base is essential.
1) Press tip of SnapSkru
chor into drywall using #2 Phillips
screwdriver or screw gun. Drive
anchor clockwise into drywall until
anchor stops flush with wall.
18-HD64D1-4
anchors must be used to mount the Control sub-base to the wall.
®
an- 2) Place sub-base over anchor
®
and insert screw.
Optional Hole
Three (3)
Recommended
Locations
3) Tighten screw flush with sub-
base. Screw "pops" open anchor,
locking anchor on wall.
Do not overtighten screws to avoid
damaging the sub-base.
Screw
5