Ge Ng  Started; Storage; Transporta On,  Loading/Unloading  &  Posi Oning; Transporta On - Firefly Cygnus CYG2400/460/24 User Manual

Cygnus portable solar generator
Table of Contents

Advertisement

2.  Ge ng  Started
2.1

Storage

1.
Cygnus  is  designed  to  be  used  and  stored  outside.  However,  to  prevent  unnecessary  weathering  it  is  recom-­‐
mended  that  the  unit  is  stored  inside  when  possible.
2.
It  is  recommended  that  the  ba ery  bank  is  charged  regularly  while  in  storage.  Refer  to  Chapter  4,  Sec on  5  for  
further  informa on.
3.
Cygnus  should  be  switched  off  when  in  storage  and  not  being  charged  to  prevent  unnecessary  discharge  of  the  
ba ery  bank.
2.2
Transporta on,  Loading/Unloading  &  Posi oning

2.2.1 Transporta on

1.
Cygnus  can  be  transported  using  a  suitable  trailer,  light  or  heavy  goods  vehicle  with  adequate  available
payload.  Check  the  relevant  transporta on  documenta on  for  suitability.
2.  
The  gross  weight  of  the  unit  can  be  found  on  the  ra ng  plate  posi oned  on  the  le  hand  side  of  
the  unit.  Please  note  that  different  models  have  different  weights.
3.  
It  is  recommended  that  the  unit  is  secured  using  suitable  straps  when  in  transit  to  prevent  it  from  moving.  
Always  check  the  ra ng  plate  to  ascertain  the  gross  weight  of  the  specific  unit  in  ques on.
The  unit  must  remain  upright  at  all   mes.

2.2.2 Loading/Unloading

1.
Cygnus  must  be  loaded  or  unloaded  using  the  correct  equipment  operated  by  suitably  trained  personnel.  
2.
Using  the  li ing  ring;  Cygnus  can  be  li ed  onto  or  off  from  transporta on.  The  li ing  ring  is  suitable  for  li ing  
all  models  of  Cygnus  regardless  of  the  unit's  gross  weight.  
3.
Using  the  fork  pockets;  Cygnus  can  be  loaded  or  unloaded  with  a  suitable  fork-li  truck.  
Refer  to  the  fork-li  truck  opera on  manual  for  li ing  capacity  and  manufacturer's  opera ng  instruc-­‐
ons.

2.2.3 Posi oning

1.
The  unit  must  be  posi oned  upright  on  a  flat,  solid  surface.  Ensure  that  the  unit  is  not  at  risk  from  being  sub-­‐
mersed  in  water  above  the  fork  pockets.  
2.
The  unit  should  be  posi oned  as  close  as  possible  to  the  chosen  charging  system  (e.g.  solar  array,    Kinectrics  
equipment,  wind  turbine)  and  close  to  its  earth  point.
Cygnus  User  Manual  -    v3.0            2011  
Page   6
 

Advertisement

Table of Contents
loading

Table of Contents