Table of Contents
Advertisement
2.4
Connec ng the Cygnus Portable Solar Generator
2.4.1 Earth a achment: Installing the Op onal Earth Rod:
1.
Find a suitable place to drive the earth rod into the ground. The earth rod should be driven down at least
600mm into the ground using a mallet and placed as near to the unit as possible.
2.
Check the earth cable is securely clamped to the rod. The clamp may need re ghtening a er driving the earth
rod down.
3.
On the control panel, locate the earth bolt (Fig. 1, C5) undo the earth bolt wing nut and remove one of the
washers. Then slide the ring terminal at the end of the earth cable onto the earth bolt. Replace the washer and
ghten the wing nut.
A protec ve earth must be connected to the unit in compliance with applicable local standards and
regula ons. This can be done either by connec ng to a suitable exis ng electrical earth, or by using an
op onal earth rod supplied by the manufacturer.
2.4.2 Connect the Inputs:
There are a number of means available to charge the unit. Instruc ons on how to connect charging inputs (e.g. solar PV,
wind turbines, Kinectrics equipment) are available as appendices to this manual or included with those products at the
point of purchase. All user manuals can also be downloaded from the manufacturer's website at www.fireflysolar.net
It is also possible to operate the unit only using the internal ba ery bank, without external inputs connected.
Care must be taken to ensure that the correct connec ons are made to avoid the risk of electrocu on
or possible damage to the unit's internal components.
Ensure that the cumula ve power of connected consumers does not exceed the maximum power out-‐
put of your unit– refer to the ra ng plate to ascertain the unit's maximum power output.
All connected consumers must be fit for purpose– refer to their ra ng plates and manuals to ascertain
the required input.
When Cygnus is connected to an external AC supply, the output voltage is transferred from its input.
In this case the unit will not modify the AC output: Consumers will be supplied with an output
iden cal to the source.
Cygnus User Manual - v3.0 2011
W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
Page 8
Advertisement
Table of Contents
