Clock - Chevrolet 2013 VOLT Owner's Manual

5-4 Instruments and Controls
INT: (Intermittent Wipes): Move
the lever up to INT for intermittent
wipes, then turn the
up for more frequent wipes or down
for less frequent wipes.
OFF: Use to turn the wipers off.
(Mist): For a single wipe, briefly
move the stalk down. For several
wipes, hold the stalk down.
Clear snow and ice from the wiper
blades and windscreen before using
them. If frozen to the windscreen,
carefully loosen or thaw them.
Damaged blades should be
replaced. See Wiper Blade
Replacement on page 10 20.
Heavy snow or ice can overload the
wipers. If the wiper motor overheats,
the windscreen wipers will stop until
the motor cools and the wiper
control is turned off. See Electrical
System Overload on page 10 25.
INT band
Wiper Parking
If the ignition is turned to LOCK/
OFF while the wipers are on LO, HI,
or INT, they will immediately stop.
If the windscreen wiper lever is then
moved to off before the driver door
is opened or within 10 minutes, the
wipers will restart and move to the
base of the windscreen.
If the ignition is turned to LOCK/
OFF while the wipers are performing
wipes due to windscreen washing,
the wipers continue to run until they
reach the base of the windscreen.
(Windscreen Washer): Pull
the windscreen wiper lever toward
you to spray windscreen washer
fluid and activate the wipers. The
wipers will continue until the lever is
released or the maximum wash time
is reached. When the stalk is
released, additional wipes may
occur depending on how long the
windscreen washer had been
activated. See Washer Fluid on
page 10 16 for information on filling
the windscreen washer fluid
reservoir.
WARNING
In freezing weather, do not use
the washer until the windscreen is
warmed. Otherwise the washer
fluid can form ice on the
windscreen, blocking your vision.

Clock

The clock is in the centre console
display.
To set the time:
1. Press the TP (Time Program)
button to go directly to the time
setting page, or press the
CONFIG button and select Time
from the list. Turn the TUNE/
MENU knob to scroll through the
available setup features. Press
the TUNE/MENU knob or press