Table of Contents
Advertisement
Quick Links
OIL FIRED WARM AIR FURNACES
ALL SUMMERAIRE SLO115 / SFLO115 MODELS
ARE AIR CONDITIONING READY !
THIS FURNACE SHALL BE INSTALLED BY A CERTIFIED INSTALLER AND
WHERE REQUIRED BY LAW, A LICENSED TECHNICIAN
IF YOUR SUMMERAIRE SLO/SFLO SERIES OIL FURNACE HAS BEEN INSTALLED USING
THE APPROVED SS1-C TJERNLUND SIDEWALL POWER VENTOR, IT IS YOUR
RESPONSIBILITY TO KEEP THE AREA AROUND THE OUTSIDE TERMINAL OF THE
POWER VENTOR CLEAR OF SNOW – ICE AND DEBRIS
______________________________
Installing Contractor
______________________________
Unit Model Number
USER MANUAL
SLO / SFLO115 SERIES
Save These Instructions For Reference
NOTICE TO HOMEOWNER
NOTICE TO HOMEOWNER
FOR SERVICE CALL:
INSTALLATION INFORMATION
________________________________
Installation Date
Summeraire Mfg.
Peterborough, Ontario
K9J 7B1
_____________________________
Telephone Number
_____________________________
Unit Serial Number
OCT., 2007R
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SummerAire SLO SERIES
Summary of Contents for SummerAire SLO SERIES
- Page 1 WHERE REQUIRED BY LAW, A LICENSED TECHNICIAN NOTICE TO HOMEOWNER IF YOUR SUMMERAIRE SLO/SFLO SERIES OIL FURNACE HAS BEEN INSTALLED USING THE APPROVED SS1-C TJERNLUND SIDEWALL POWER VENTOR, IT IS YOUR RESPONSIBILITY TO KEEP THE AREA AROUND THE OUTSIDE TERMINAL OF THE POWER VENTOR CLEAR OF SNOW –...
- Page 2 OPERATING INSTRUCTIONS CAUTION: NEVER BURN GARBAGE, REFUSE OR PAPER IN THE HEATING UNIT. NEVER LEAVE COMBUSTIBLE OR OTHER MATERIALS AROUND OR NEAR THE FURNACE. IDENTIFY THE LOCATION OF YOUR BURNER / FURNACE POWER SWITCH OIL BURNER OPERATING INSTRUCTIONS • Use No 2 furnace oil ONLY • Do not use gasoline, crankcase oil, or any oil containing gasoline.
- Page 3 BURNER FAILS TO OPERATE Always call a qualified technician The trouble may be : • Raise your thermostat to 5º C ( 10º F ) above present room temperature • Make sure your “ Oil Burner “ power switch is in the “ON” position • If you hear a hum from the oil burner, and the motor has not started, press the reset button on the burner motor once only. • Blown fuse / “tripped” breaker in electrical panel • Thermostat may be set below room temperature. • Burner relay ( combustion control ) may have to be “reset” ( press reset twice only ) • Oil valve may be closed. • Oil supply may be too low. • Manual reset fan and limit control may be “tripped” • Blocked flue sensor “tripped” • If the oil burner fails to start or runs for only a few seconds, call a qualified service technician OIL FURNACE ANNUAL SERVICE The oil burner and furnace should be thoroughly cleaned and serviced annually by a qualified service tech- nician, and where required by law, a licensed technician. CAUTION: Do not use any commercially available soot remover. Use extreme caution when servicing since the combustion chamber is fragile. Routine cleaning of the flue passages does not require cleaning the combustion chamber. If for some reason, it is necessary to work in the area of the combustion chamber, do not touch or alter the chamber position.
- Page 4 A DIRTY AIR FILTER CAUSES INEFFICIENCY AND HIGHER OPERATING COSTS Clean or replace filters each heating season, or as required. Filter specifications for the air filter installed in your Summeraire oil fired warm air furnace, are listed below. DO NOT SUBSTITUTE ! Note: Changing the type or size of filter used in your Summeraire furnace can seriously affect the operation of the furnace! AIR FILTER SPECIFICATIONS Filter size: 20” X 20” X 1” – CSA or ULC Certified/Approved Type: Throw-away/disposable USE OF FILTERS OTHER THAN THOSE SPECIFIED ABOVE, CAN CAUSE DANGEROUS ELEVATION OF FURNACE TEMPERATURES –...
- Page 5 Laundromats, Beauty Salons, etc. 11. Summeraire Mfg. shall not be responsible for any failure due to water damage and/ or Acts of God. 12. No Air Conditioning or Heat pump coil may be installed on the return air side of this furnace.
Need help?
Do you have a question about the SLO SERIES and is the answer not in the manual?
Questions and answers