Page 1
USER MANUAL ELECTRIC WARM AIR FURNACE MODELS - SE10B (E) TO SE27B (E) Save these instructions for reference This furnace must be installed by a certified installer and where required by law, a licenced technician. FOR SERVICE CALL: INSTALLATION INFORMATION...
Page 2
OPERATING SEQUENCE HEATING When the thermostat initiates the heating cycle the first and second sequencer turn on in sequence, the remaining sequencer relays are activated. The on delay time is determined by the sequencer relay model. The blower starts at heating at the same time as the first element turns on.
Page 3
REMEMBER, during the winter months, this switch should be in the “ON” position to insure maximum heating capacity. The POWER switch must be set in the “MAX” position when a 2 – stage thermostat or outdoor thermostat is installed and used to control the electric elements of the second stage.
This furnace should never be operated without filters. A DIRTY AIR FILTER CAUSES INEFFICIENCY AND HIGHER OPERATING COSTS Clean or replace filters each heating season ! Filter specifications for the air filter installed in your Summeraire electric warm air furnace, are listed below. DO NOT SUBSTITUTE !
Page 5
Filter size : 20 “ X 20 “ x 1 “ – CSA or ULC Certified /Approved Type: Disposable Note: Changing the type or size of filter used in your Summeraire furnace can seriously affect the operation of the furnace!
Page 6
WARRANTY Summeraire Mfg., subject to the limitations described in this Warranty Certificate, warrants each electric warm air furnace as follows. 1 ) All electric controls are warranted for a period of five ( 5 ) years from date of sale.
Page 7
10) Summeraire Mfg. shall not be responsible for any consequential damages caused by any defect in the product. 11) This is the ONLY warranty made by Summeraire Mfg. All other warranties, conditions or guaranties, expressed or implied are hereby excluded.
Need help?
Do you have a question about the SE10B and is the answer not in the manual?
Questions and answers