Advertisement
3. The display will show a random number.
4. Press the [ MODE ] key. The display will show the
first required calibration weight.
5. Place the required weight on the scale and press
the [ MODE ] button.
6. The display will now show the second required
calibration weight.
7. Place the required weight on the scale and press
the [ MODE ] button.
8. [SC-501 only] The display will now show the third
required calibration weight.
9. [SC-501 only] Place the required weight on the
scale and press the [ MODE ] button.
10. The display will show "PASS". Calibration is
complete
IV. TROUBLESHOOTING
The primary reasons for inaccuracy or malfunction
are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in
mind and maintain and operate your scale properly.
This scale is a precise instrument and must be
handled with the utmost care and caution.
[Display] Elimination of errors
[Lo] Change the batteries.
[OUE2] Recalibrate the scale as shown above.
[O_Ld] You are overloading the scale. Remove the
excessive load immediately!
[UnST] Use the scale in a more stable position
Advertisement
