Icom IC-F3160 SERIES Operating Manual page 41

D Transmitting a Status Polling Call
The transcever can send a sgnal that causes the targeted
staton to automatcally transmt ts current status.
q Push [Digital Button] to enter the applcaton selecton
mode.
• "VOICE" appears.
• To change the call type, push and hold [Digital Button] for 1 sec.
durng stand-by operaton. After changng, the transcever en-
ters the applcaton selecton mode automatcally.
w Push [CH Up] or [CH Down] to select "STAT POL."
e Push [Digital Button] agan to enter the Indvdual ID se-
lecton mode.
• The pre-programmed ID name s dsplayed.
• When ID name s not programmed, ID code s dsplayed.
r Push [CH Up] or [CH Down] to select the desred ID
name (or ID code).
• Dependng on the pre-settng, you can nput the ID drectly.
(10-key verson only) See p. 39 for detals.
Individual ID name
is displayed.
STAT POL
STATION 1
DIGI STUP STDN
t Push [PTT] to transmt the status pollng to the selected
staton.
• "STAT POL" s dsplayed.
y Release [PTT].
• The status message s dsplayed when the targeted staton
send the status.
• "POL FAIL" s dsplayed f there s no acknowledgment from the
staton.
u After a specfied tme perod has passed, the transcever
wll return to receve.
5
IDAS OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
38