Cleaning; Opening The Stroller; Fitting And Removing The Wheels; Fitting The Seat - Chicco I-Move Instructions For Use Manual

er give children objects with cords or
strings attached, or leave them within
their reach.
• WARNING: never use the stroller on
staircases or escalators: you could sud-
denly lose control of it. Always pay at-
tention when going up and down steps
or pavements.
• If the stroller is left exposed to direct
sun light for a long time, allow it to
cool down before placing your child in-
side. Prolonged exposure to direct sun
light may cause the colour of the ma-
terials and fabric to fade.
• Do not use the product if any parts are
broken, torn or missing.
• WARNING: Check that the pram body
or seat unit attachment devices are
correctly engaged before use
• WARNING: when it is not being used,
the stroller should be kept out of chil-
dren's reach.
• WARNING: This product is not suitable
for running or skating
• Prevent the stroller from coming into
contact with salt water. It may cause
the formation of rust and corrosion.
• Do not use the stroller on the beach.
• WARNING: this product must only be
used by an adult.
TIPS FOR CLEANING AND MAINTENANCE
This product requires periodic maintenance. The cleaning
and maintenance operations must only be carried out by
an adult.

CLEANING

The stroller has a removable lining (please refer to the
"Removable lining" section). Please refer to the care label
for instructions on cleaning the fabric parts. Please find
below the washing symbols and relative meanings:
Hand wash in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Use a soft cloth to clean the plastic parts on a regular ba-
sis. Always dry any metal parts that come into contact
with water to prevent the formation of rust.

MAINTENANCE

Lubricate the moving parts, if necessary, with a dry sili-
con oil. Periodically check the condition of the wheels and
keep them clean of dust, dirt and sand. Make sure all plas-
tic parts that slide along the metal tubes are clean and
free from dust, dirt and sand; this will avoid friction that
may prevent the stroller from working properly. Keep the
stroller in a dry place.

OPENING THE STROLLER

WARNING: when opening the stroller, make sure that
your child and all other children are at a safe distance. En-
sure that during these operations the moving parts of the
stroller do not come into contact with your child.
1. Raise the handlebar until it locks in place (diag. 1).
2. Lift the frame until it reaches the position illustrated
in Diagram 2.
3. Press the open/close lever (A) following the instruc-
tions below: move it to the left (1) and then upwards (2)
as seen in diagram 3.
4. Push the rear leg outwards until it reaches the lock po-
sition (diagram 4).
WARNING: make sure the Stroller is locked in the open
position.
5. Release the snap-clasps on the handle (diagram 5A)
and move the handlebar to the position illustrated in dia-
gram 5B.

FITTING AND REMOVING THE WHEELS

6. Insert the wheel pin into the hole on the rear leg tube,
as illustrated in diagram 6. Repeat the operation for both
wheels.
7. The rear wheels can be removed. Press the button in the
centre of the wheel and slide it off the pin (diagram 7).

FITTING THE SEAT

8. To assemble the seat onto the stroller frame, grasp both
sides of the seat with two hands and connect the base to
the frame (diagrams 8A and 8B) so that the groove on
the seat (A) is aligned with the arrows on the frame (B)
(diagram 8C). Adjust the position of the seat until it clicks
securely into place.
SAFETY HARNESS
The stroller comes with a five-point safety harness which
consists in two shoulder straps, a lap belt and a crotch
strap with a buckle.
WARNING: always use the shoulder strap when carrying
children from 0 to 6 months of age.
9. Thread the safety clasps through the fabric loops (diag.
9) and check that the shoulder straps are fitted at the
right height for the child: if this is not the case, adjust the
height as necessary.
10. Bring the upper harness strap clasp (A) in line with the
triangle on the lap belt clasp (B) (Diagram 10) and then in-
sert them both in the harness buckle (C). Slide the harness
straps along the plastic rings until they are tight enough.
Press the centre button (D) to release the safety harness
straps.
For extra safety, the stroller is fitted with D-rings which
can be used to fit a separate safety harness, compliant
with BS 6684 Standards. The rings are fitted internally on
the right and left side of the stroller seat (diag. 10B).
WARNING: the safety harness must always be fastened
to guarantee complete safety for your child.
PARKING BRAKE
The parking brake control lever is fitted on the stroller
handlebar,
11. To activate the brake, turn the lever counter clockwise
until it locks in place, and the red brake ON indicator is
9