Cleaning And Maintenance - Chicco TOGETHER Instructions For Use Manual

materials and fabric to fade.
parts are broken, torn or missing.
stroller should be kept out of children's reach.
running or skating.
coming into contact with salt water. It may
cause the formation of rust.
beach.
by an adult.
unit attachment devices are correctly engaged
before use.

CLEANING AND MAINTENANCE

The cleaning and maintenance of this product must be carried
out on a regular basis by the user. The cleaning and maintenance
of the stroller must only be carried out by an adult.
CLEANING
The cover cannot be removed. Clean all fabric parts with a
damp sponge and neutral detergent. Please refer to the care
labels for instructions on how to clean the fabric parts. Below
are the cleaning symbols and their meanings:
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Periodically wipe clean plastic parts with a soft damp cloth.
Always dry the metal parts to prevent the formation of rust if
the stroller has come into contact with water.
MAINTENANCE
Lubricate the moving parts only if necessary, with the light
application of a silicone based lubricant. Regularly check the
condition of the wheels and, keep them clean of dust and sand.
To avoid friction that may prevent the correct operation of the
stroller, ensure that all the movable plastic parts placed along
the metal frame are clean of dust, dirt or sand. Keep the stroller
in a dry place.
GENERAL INSTRUCTIONS
ASSEMBLING AND OPENING THE STROLLER
CARRY-ALL TRAY
inside the carry-all tray. The 2 tabs on the end of the carry-all
tray are used to fasten it to the stroller frame: slide the 2 tabs
tray towards the handlebar until you hear it click into place
Check that the closing mechanism wire does not interfere with
the carry-all tray fasteners.
HOW TO OPEN THE STROLLER
WARNING: before you start, check that your children are at a
safe distance.
Ensure that during these operations the moving parts of the
stroller do not come into contact with your child.
2. Once the carry-all tray has been fastened to the frame,
now open the stroller by using your other hand to push the
front section of the frame downwards, until you hear it click
Make sure the stroller is open properly before proceeding any
further.
4. To adjust the height of the handlebar, press the two side
the required position.
BASKET
5. The stroller comes with a practical carry-all basket. To
assemble the basket, slide the U-shaped tube into the tube
ends on the back of the stroller, as seen in diag. 5A. The
on the bottom, protruding from the holes below the stroller
frame tubes and you hear them click into place.
inserted properly. Always remove all contents from the basket
before you close the stroller.
to access it more easily.
FITTING THE BACK WHEELS
using the stroller.
Make sure you insert the fastening spring pin as indicated in the
whilst the closed end of the spring pin must be facing outwards
following the instructions in the same order.
FITTING THE FRONT WHEELS
10. Slot the front wheel block onto the stroller frame as seen in
diag. 10, until you hear it click into place. Repeat this procedure
for the other wheel block.
21