Enabling Or Disabling The Internal Usb Port - Cisco UCS C240 Installation And Service Manual

Replacing an Internal SD Card

Enabling or Disabling the Internal USB Port

The factory default is for all USB ports on the server to be enabled. However, the internal USB port can
be enabled or disabled in the server BIOS. To enable or disable the internal USB port, follow these steps:
Enter the BIOS Setup utility by pressing the F2 key when prompted during bootup.
Step 1
Navigate to the Advanced tab.
Step 2
On the Advanced tab, select USB Configuration.
Step 3
On the USB Configuration page, select USB Ports Configuration.
Step 4
Scroll to USB Port: Internal, press Enter, and then select either Enabled or Disabled from the pop-up
Step 5
menu.
Press F10 to save and exit the utility.
Step 6
Cisco UCS C240 Server Installation and Service Guide
3-74
Chapter 3 Maintaining the Server
OL-25761-01