Cisco UCS C240 Installation And Service Manual page 73

Chapter 3 Maintaining the Server
Figure 3-15
CPU retaining latch,
1
CPU retaining latch,
2
Remove a protective cap or an old CPU from the socket (if present):
Step 2
If you are removing an old CPU, skip to
•
If you are installing a new CPU to a socket that was shipped empty, the socket has a protective cap
•
that is intended to prevent bent contact pins. Use the tool as shown in
protective cap and then pivot to remove the cap.
Figure 3-16
Remove an old CPU:
Step 3
Set the Pick-and-Place tool on the CPU in the socket, aligning the arrow on the tool with the
a.
registration mark on the socket (the small triangular mark). See
Press the top button on the tool to grasp the installed CPU.
b.
Lift the tool and CPU straight up.
c.
Press the top button on the tool to release the old CPU on an anti-static surface.
d.
OL-25761-01z
CPU Heatsink and Socket
2
1
3
Protective Cap Removal Tool
Installing or Replacing Server Components
Hinged CPU cover plate
3
–
Step 3.
Figure
Cisco UCS C240 Server Installation and Service Guide
Figure 3-16 to grasp the
3-17.
3-31