Enabling Or Disabling The Internal Usb Port - Cisco UCS C240 M4 Installation And Service Manual

Chapter 3 Maintaining the Server
Figure 3-24
1

Enabling or Disabling the Internal USB Port

We do not recommend that you Hot-swap the internal USB drive while the server is powered on.
Caution
The factory default is for all USB ports on the server to be enabled. However, the internal USB port can
be enabled or disabled in the server BIOS. See
on the motherboard.
Enter the BIOS Setup Utility by pressing the F2 key when prompted during bootup.
Step 1
Navigate to the Advanced tab.
Step 2
On the Advanced tab, select USB Configuration.
Step 3
Step 4 On the USB Configuration page, choose USB Ports Configuration.
Step 5 Scroll to USB Port: Internal, press Enter, and then choose either Enabled or Disabled from the dialog
box.
Step 6 Press F10 to save and exit the utility.
OL-32474-01
SD Card Bay Location and Numbering on the Motherboard
SD card bays SD1 and SD2
Installing or Replacing Server Components
1
Riser 2
Riser 1
Figure 3-5 for the location of the internal USB 3.0 slot
Cisco UCS C240 M4 Server Installation and Service Guide
3-41