Cisco UCS C240 Installation And Service Manual page 99

Chapter 3 Maintaining the Server
Figure 3-32
PCIe riser 1 slots (Slots 1, 2, 3)
1
Open the riser's hinged card retainer and the long-card retainer (see
a.
Align the GPU card with the socket on the riser, then gently push the card's edge connector into the
b.
socket. Press evenly on both corners of the card to avoid damaging the connector.
Close the hinged card retainer, then the long-card retainer over the end of the card.
c.
Figure 3-33
1
Long-card retainer
1
Card socket
2
If you are installing a second GPU card, repeat the actions in
Step 4
Note
Install the new PCIe risers:
Step 5
Install any other PCIe cards that you want to install into the new risers.
a.
Note
Install riser 2 first. Position the PCIe riser over its socket on the motherboard and over its alignment
b.
slots in the chassis (see
OL-25761-01z
Rear Panel, Showing PCIe Risers and PCIe Slots
PCIe 5
PSU1 PSU2
PCIe Riser (Slot 5 on PCIe Riser 2 Shown)
When a GPU card is in slot 2, slot 1 is blocked and unavailable for use.
If you are installing a Cisco UCS Virtual Interface Card (VIC), see the slot restrictions in
Considerations for Cisco UCS Virtual Interface Cards, page
Figure
2 1
PCIe 1
PCIe 2
PCIe 4
PCIe 3
PCIe riser 2 slots (Slots 4, 5)
2
2
Hinged card retainer for PCIe slot 5
3
3-34).
Cisco UCS C240 Server Installation and Service Guide
Installing or Replacing Server Components
Figure 3-33).
Step 3 for PCIe slot 2 on the second riser.
3-43.
3
Special
3-57