Enabling Or Disabling The Internal Usb Port - Cisco UCS C240 M4 Installation And Service Manual

Replacing an Internal SD Card

Enabling or Disabling the Internal USB Port

Caution We do not recommend that you Hot-swap the internal USB drive while the server is powered on.
The factory default is for all USB ports on the server to be enabled. However, the internal USB port can
be enabled or disabled in the server BIOS. See
on the motherboard.
Step 1 Enter the BIOS Setup Utility by pressing the F2 key when prompted during bootup.
Step 2 Navigate to the Advanced tab.
Step 3 On the Advanced tab, select USB Configuration.
On the USB Configuration page, choose USB Ports Configuration.
Step 4
Scroll to USB Port: Internal, press Enter, and then choose either Enabled or Disabled from the dialog
Step 5
box.
Step 6 Press F10 to save and exit the utility.
Cisco UCS C240 M4 Server Installation and Service Guide
3-40
Chapter 3
Figure 3-5 for the location of the internal USB 3.0 slot
Maintaining the Server
OL-32474-01