Lionel Rover’s Revenge Owner's Manual page 6

Controlling the accessory in the Command Control environment
(continued)
SC-2 wiring and operation
T hree wires (not included) are needed to connect the accessory to the SC-2 and a separate
accessory transformer. Refer to Figure 3.
1. Attach one wire to the transformer Common/Ground/U terminal and connect it to the
accessory COMM (common) position on the SC-2.
2. Attach a wire to one of the accessory terminals and connect it to the accessory ON/OFF
toggle position on the SC-2.
3. Attach a wire to the other accessory terminal and connect it to the transformer Power/A
terminal.
Use the AUX2 button on your CAB-1 Remote Controller to toggle the accessory
ON and OFF.
Figure 3. SC-2 connections
6
ACC1 ACC1
ACC2 ACC2