Install the TPM board. Press down on the connector to seat the board
9.
page 8).
Install the TPM security rivet by pressing the rivet firmly into the system board.
10.
Install the front panel/drive cage assembly.
11.
Install the SAS controller (on page 16).
12.
Install the DIMM baffle.
13.
Install the access panel (on page 14).
14.
Install the server blade
15.
Power up the server blade (on page 12).
16.
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
("Installing a server
blade" on page 21).
("System board
components" on
Hardware options installation 41