Clearaudio Performance DC User Manual page 9

2.7
For tonearm and cartridge mounting please refer to the user manual of the respective
manufacturer.
Now you can connect the
Pic. 8: Connection to the main supply
2.8
Speed fine adjustment
The motor adjustment is already pre set at the factory. Because of handling or because of soiling of
the sensor or the sensor ring, some small speed deviations can occur.
Please check the speed before using the turntable for the first time.
For the correct adjustment of the speed, please put the recommended clearaudio Stroboscope
Testrecord on the platter. Follow the instructions of the Stroboscope Testrecord user manual. To
check the speed with highest accuracy please use the clearaudio Speed Light (AC039)
On the backside (close to the power supply input) of your turntable there are three setting
trimmers:
Pic. 9: Speed fine adjustment
Page 9
Performance DC
turntable with the main supply.
Performance DC
- left trimmer = setting 45 rpm
(near power supply jack)
- right trimmer = setting 78 rpm
33 1/3 RPM is underneath the motor
 clearaudio electronic GmbH 2013
User manual