Clearaudio Performance DC User Manual page 7

Performance DC
User manual
2.3
Now you can set the bearing upper part carefully onto the bearing.
To avoid damages make sure you slide the bearing upper part slowly and carefully on the polished
ceramic shaft.
Pic. 4: Fitting the bearing upper part
2.4
Now you can set the sub-platter carefully onto the bearing.
To avoid any damage, make sure you slide the sub-platter slowly and carefully onto the bearing.
After that, take the included belt and place it around the motor and the sub-platter. At this point the
sub-platter will be higher than the pulley. This is normal, as the CMB requires the weight of the
platter to fully engage it.
Pic. 5: Setting the sub-platter Pic. 5.1: Moving the belt
Page 7  clearaudio electronic GmbH 2013