Table of Contents
Advertisement
OWNER'S MANUAL
UNPACKING
Install "AA" battery in the pilot igniter box
under the gas component tray before trying to
light the unit.
The DVI-Ht is packaged by the manufacturer to
withstand shipment, without damage, under most
circumstances.
However, damage can occur during
transit and handling.
unpacking, inspecting for damage, and installing the
unit. If any damaged or missing parts are detected,
immediately contact your dealer.
A complete DVI-Ht is shipped with three packages.
Locate and remove these packages. Package #1 will
contain the Log Set. Package #2 will contain the front
set, doors, and grills. Package #3 will contain the
optional surround if ordered. Lift the stove off the pallet
and partially insert it into the fireplace, (with regards to
the Clearances To Combustibles section on page 7 of
this manual). Carefully remove the surround set and
front set from the packaging carton.
Components
1-DVI -Ht (with accessory box)
- 4 Decorative logs
- 1 Pilot shield
- 1 Bag of Embers
- 40' Wire
- 1 Thermostat
- 1 LP Conversion Kit
- 1 Restrictor Disc
-
2 Metal Surround Flanges
Façade Assembly
-
See packing list.
Surround Assembly
-
See packing list
WARNING: do not strike, hit or slam
the glass shut in any way. It may cause
injury or disturb the performance of the
appliance
be taken when
Care should
Inspect for Damage
Inspect the DVI-Ht for visible and/or concealed damage.
The unit should appear to be square and true. The sheet
metal parts should be smooth and free of bends and/or
dents. If the facade is enameled, the enameled cast iron
should be free of chips and/or cracks.
concealed damage is found or suspected, contact your
local dealer for instructions. To open the firebox, reach
over the firebox, and under the front grill. With a flat
screwdriver turn the retaining clips up. There will be
four separate clips. Be careful, when you lift the last one,
as it will free the glass and frame from the unit. Pull the
top of the glass towards your body, and lift the glass and
frame up and away from the unit. Carefully set the glass
and frame away from the unit, as it will need to be
installed later. Inspect the log set for damage. It is
important to wear safety goggles and gloves when
handling the log set. If a damaged log is encountered,
contact your local dealer for a replacement log. Put the
log set, aside. It will be installed later.
You Will Need the Following to Complete the Installation
Surround Set
Two - 3" Flex Liners (Dura-Vent #2280)
Co-Linear Chimney Liner Termination Kit (Dura-Vent
#923GK)
High Wind Termination Cap (Dura-Vent #991)
Four - 3.5" Hose Clamps
Gas Hookup Equipment/Tools
High Temperature Silicone
Small Level
Phillips Screwdriver
Slotted Screwdriver or 5/16" Nut Driver
Thread Sealant
Open End Wrenches or Adjustable Wrench
Permanent Marker
Fiberglass insulation
Safety glasses
Gloves
An external regulator (for Propane/L.P. gas only)
Gas piping which complies with local codes
Pipe sealants approved for use with propane/L.P. Gas
(resistant to sulfur compounds)
A sediment trap
Pipe wrenches
6
Model # 8890 DVI-Ht
Of The Unit
If visible or
Advertisement
Table of Contents
