Page: 58
Service Manual - OKIPAGE20
Chapter 4 Adjustment
This chapter explains the adjustment necessary when replacing a part. Adjustment is made by changing a
parameter value set in EEPROM on the controller PCB. A parameter is able to set with the key operation
on the operator panel. This printer has three kinds of the maintenance mode, it is required to select one of
the maintenance mode necessary when replacing a part.
4.1 Maintenance Modes and Functions
4.2 Adjustment When Replacing a Part
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)