Starting The Engine - Northern Lights OM-C3 Operator's Manual

Starting the Engine

The following instructions apply to the optional controls
and instruments available through the John Deere Parts
Distribution Network. The controls and instruments for
your engine may be different from those shown here;
always follow manufacturer's instructions.
CAUTION: Before starting engine in a confined
engine room, install proper outlet exhaust
ventilation equipment. Always use safety
approved fuel storage and piping.
NOTE: If temperature is below 0°C (32°F), it may be
necessary to use cold weather starting aids (See
COLD WEATHER OPERATION, later in this section).
1. Perform all prestarting checks outlined in Lubrication
& Maintenance/Daily Section later in this manual.
2. Open the fuel supply shut-off valve.
3. Set marine gear control lever in the "NEUTRAL"
position on propulsion units.
4. Move the throttle control lever approximately 1/3 of the
way off the idle position.
5. Turn the key switch to the ON position. The "Wait To
Start Preheating" message will be displayed when
ambient temperatures require preheating (for engines
with preheating options). The timer will display minutes
and seconds, counting down to zero. Once the timer
Engine Operation
has reach 0:00 and the "Wait to Start" message is no
longer displayed, you may start the engine.
Continued on next page
OM-C3 | 12/6 | 17
Use Proper Ventilation
Wait To Start Screen
RG19661,00003BD -19-23JAN13-1/2