Alert Notification; Selecting A Tone Length - Sanyo SCP-3200 User Manual

Selecting a Vibrate Type
With this feature, you can select a vibrate type for incoming calls,
messages, and alarms.
To select a vibrate type:
1.
Select
2. Select Incoming Calls, Push 2 Talk, Voicemail, Messaging, or
Calendar/Alarm. The following items require an additional step:
Incoming Calls: select With Caller ID or No Caller ID.
Push 2 Talk: select Push 2 Talk Calls or P2T Missed.
Messaging: select Text or Picture Msg.
3.
Select a vibrate type and press

Alert Notification

Your phone can alert you with an audible tone when you change
service areas, once a minute during a voice call, or when a call has
been connected.
To set alerts:
1.
Select
2.
Select your desired option and press
Service sets an alert to notify you of network services
parameter changes.
Push 2 Talk sets an alert to notify you of Push 2 Talk calls.
Voicemail sets an alert to notify you of voice messages.
Messaging sets an alert to notify you of text or picture
messages.
Minute Beep sets a minute reminder that beeps ten seconds
before the end of each minute during a call.
Signal Fade sets an alert to notify you when your phone
loses a signal during a call.
3.
Use your navigation key to select a setting and press

Selecting a Tone Length

This setting is valid only when "Tone Type" is set to "Type 1". See
"Selecting a Tone Type" on the next page.
1.
Select
2. Select Short or Long.
> Settings > Sounds > Vibrate Type.
> Settings > Sounds > Alerts.
> Settings > Sounds > Others > Tone Length.
.
.
4. Your Phone's Settings
.
33