Hot Surface Light Replacement; Burner Replacement - GE JP938 Technical Service Manual

2. Remove 4 screws from the switch mounting
bracket (2 from each end).
3. Remove 2 screws and the switch from the
mounting bracket.
4. Tag and remove the wires from the switch.

HOT SURFACE Light Replacement

1. Remove the glass and cooktop from the
countertop (see procedure).
2. Remove 2 screws from the burner box and
remove the HOT SURFACE light mounting
bracket.
3. With a small screwdriver, push in on the first
light tab while pushing down on the light. Push
in on the second light tab, while still pushing the
light down, to release the light.
4. Remove 4 screws from the switch mounting
bracket (2 from each end) and remove the red
wire from the switch for the left rear burner.
5. Note the location and color of the wires in the
wire harness, disconnect them from the burn-
ers, and remove.
Note: When installing the new HOT SURFACE
light, be sure to feed the harness under the brace
below the right-hand burners.

Burner Replacement

1. Remove the glass and cooktop from the
countertop (see procedure).
2. Note the position of the wires to the burner.
Remove the wires.
– 20 –
LR Burner Switch LR Burner Switch
GEA00814