How to Arm the System
Arming the system in any mode is performed in the same way, as described below.
Note: Close all perimeter windows and doors before arming.
Arm the system as follows:
ICON
1. From the "Home" screen, touch the
SECURITY icon.
2. Touch the selected arming icon.
-a text message appears stating which zones are
arming and whether or not there is an entry delay
-the screen changes to display the remaining exit
delay time, and
-the exit delay time continues to count down to
one.
How to Arm Multiple Partitions
Note: Some systems may not have multiple partitions and the "Arm Multi-Partitions" icon may not be displayed.
To arm multiple partitions, do the following:
ICON
1. From the Home screen, touch the Security
icon and then the Arm Multi-Partition icon.
2. Select the appropriate arming mode.
3. Enter the user code authorized to access
other partition(s).
4. Highlight the partition from the list on
the screen, and touch OK.
5. Select ALL to arm all partitions listed.
ACTION
Note: If Quick Arm is Not enabled in your system, you are prompted to
enter your User Code.
When exit delay time expires, the screen automatically changes to indicate
the system is "Armed".
ACTION
Notes:
When exit delay time expires, the screen automatically changes to indicate
the system is "Armed".
Note: If any zones are bypassed, a "Display Faults" icon (
displayed on this screen.
11
NOTES
•
When the system is armed for Stay, Night Stay and Instant mode,
the keypad beeps 3 times.
•
When the system is armed for Away and Maximum mode, you
will hear steady beeps then rapid beeping during the last 10
seconds of Exit Delay.
NOTES
•
A user may have access to some or all of the available partitions.
•
If the user code is accepted, the system displays the partitions that
the user has access to.
Security (cont'd)
) is