Care - Radio Shack 43-3703 Owner's Manual

Symptom
Severe noise interference.
The Caller ID does not
display.
You cannot register the
handset at the base.
The handset doesn't
communicate with
another handset.
The handset can't join the
conversation
Room Monitor feature does
not work.
If you still have problems, disconnect the phone. If other phones on the
same line work properly, the fault is in this phone or its installation. If you
cannot find the problem, take the phone to your local RadioShack store
for assistance.

CARE

Keep the phone dry; if it gets wet, wipe it dry immediately. Use and store
the phone only in normal temperature environments. Handle the phone
54
Suggestion
• Keep the handset away from microwave ovens,
computers, remote control toys, wireless
microphones, alarm systems, intercoms, room
monitors, fluorescent lights, and electrical
appliances.
• Move to another location or turn off the source
of interference.
• The handset was picked up before the second
ring.
• The call was placed through a switchboard.
• Call your local telephone company to verify your
Caller ID service is current.
• Charge the battery pack for 15-20 hours.
• De-register the handset (see "De-register the
Handset" on page 27) and register the handset
(see "Register the Handset to the Base" on
page 49).
• De-register the handset (see "De-register the
Handset" on page 27) and register the handset
(see "Register the Handset to the Base" on
page 49).
• Make sure that you have registered both the
handsets.
• Make sure there are not two handsets already
using the three-way conference feature.
• Make sure that another handset is not in privacy
mode.
• Make sure both handsets (or the handset and
the base) are set to Room Monitor mode and
that both are turned on.
• Make sure to place the handset(s) within the
range of the base.