Radio Shack 43-3703 Owner's Manual page 47

"Viewing the Caller ID List" on
page 45).
2. Press
TALK/FLASH
phone will automatically select a free
line. To select a particular line, press
the or
LINE1
displayed phone number dials
automatically.
Long Distance calls and Area Code
Setting/Cancellation
While the present Caller ID information is
displayed, pressing
remove the prefix "1" in the display to set
the call for a long distance call, or pressing
will set or cancel an area code (see
#/>
"Setting the Area Code" on page 25). Ô
Storing Caller ID messages in the
Phonebook
Messages shown in the Caller ID list can be
stored in the phonebook. The phone
number and name of the party on the Caller
ID list can be stored in memory. Ô
1. When the phone is in standby mode,
view the Caller ID message to be
stored.
Then press the
2. Press
CID/VOL/
select Store into PB?
soft key. If the Caller ID message is
already stored in memory, you will hear
a beep and This data is already
stored! ! appears. The number will
not be stored.
3. To complete the setting, follow the
steps 3-8 in "Storing Phone Numbers,
Names, Distinctive Rings, and Speed
Dial" on page 37-38.
or
SPEAKER
soft key. The
LINE2
will place or
/TONE/<
soft key.
EDIT
or
REDIAL/P/
, and the
. The
Ô
• When a long distance
call has been set,
appears in the display.
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information is
stored.
• If the Caller ID message
was received as a
private/unknown
number, or the message
does not have the
number, you cannot
store the message in the
Phonebook. If it was
received as private/
to
unknown name, the
message will be stored
OK
as <No Name>.
• Even if the 100 memory
locations are full, the
message will be stored
in the Phonebook.
However, the message
will be erased from the
Caller ID list.
Ô
NOTES
1
47