Door Handle Assembly - Midea WQP6-3206B Technical Service Manual

connecting rod. When activated for the second time in a cycle, the lever lifts the connecting
rod by the notch, lifting the rinse dispenser plunger and releasing the rinse agent. When
deactivated, the lever returns to its original starting position. The magnetic sensor is connected
to rinse aid warning light at control panel by wires. When the indicator lights up, it should add
more rinse aid.
1
2
3
Part Name: 1 – cover catch 2 – detergent power compartment
3 – cover 4 –sight glass
5 – rinse agent cap 6 – detergent tablet compartment
1
2
Part Name: 1 – electromagnetic valve 2 – lever
3 – plunger 4 – connecting rod
5 – magnetic sensor
Removal and Replacement
1. Remove outer door assembly. (see outer door removal and installation)
2. Pull out all terminals of dispenser. Then remove all screws for fixing dispenser.
Locking terminals
Part Name: 1 – dispenser brackets 2 – dispenser
5. Reverse the above procedure to install. And check out all connectors connects well.
Door Handle Assembly
Removal and Replacement
1. Disconnect power supply.
2. Remove outer door assembly. (see outer door
removal and installation)
3. Unfit all snap-fits of outer door assembly for fixing
microswitch (door handle assembly). And pull out
microswitch (door handle assembly).
Note
: Don't pull out all terminals of microswitch (door handle assembly)
4
5
6
3
4
5
Screws
1
2