Whip Mix Pro Press 100 Operation Manual page 36

Pro Series Furnace Operations Manual
10. Retrieve the new muffle assembly and inspect it for
particles and cracks
11. Reinsert the O-ring and carefully place the muffle
assembly onto the O-ring and casting. Some
alignment may be needed.
12. Place the fan on top of the lid of the new muffle assembly
and insert the bolts loosely. Make sure to insert one tab of
the fan thermostat under the fan mount before tightening
the screws. Make sure to center the fan thermostat in the
thermal joint compound (white paste).
13. Insert the other two bolts toward the back and tighten
all four in a crisscross pattern until the muffle assembly
is tightly connected to the casting.
14. Replace the press cylinder and tighten into place
with the four Allen bolts. While inserting the cylinder
be careful not to damage the insulation. Also check
for rod clearance.
15. Reconnect press valve hoses by gently tugging on
the hose to confirm catch. Remember, the hose on the
bottom of the valve goes to the top of the press cylinder
and the hose to the top of the valve goes to the bottom
of the press cylinder.
Figure 52
16. Wrap the thermocouple bolt threads with
17. Insert the thermocouple into the lid and slowly tighten.
18. Reconnect all other wires and replace top cover.
19. Run vacuum test again with idle temperature set at 0° C.
Moisture burnout and muffle burn in procedures
1. Muffle Burnout
Press Board
Note: Make sure
the wires face the
back of the furnace.
Thermocouple
Press Regulator
Press Adjust
This will burn out all binders in the ceramic fiber insulation.
When the table lowers, clean the table with a paper towel
and Windex
these will remove the anodized finish and ruin the table.)
Top O-ring
36
tape clockwise with the tip facing you at least three
full (360 degree) revolutions.
Make sure to orient the press sensor wire correctly
on the press cylinder (wires facing the back).
(See Figure 52.)
2 Bottom O-ring Checks:
• Cracking or peeling
• Suppleness
• Loose particles
DO NOT FORGET TO PLACE THE FIRING TRAY
ON THE LIFT TABLE!
A. Press the Special Functions button.
SELECT ITEM:
CHANGE IDLE TEMP
Figure 53
B. Turn the Select Knob to select CHANGE IDLE
TEMP. Press the Next button.
CHANGE IDLE TEMP
NEW IDLE
Figure 54
C. Turn the Select Knob to indicate NEW IDLE – 651C.
Press the Next button.
CHANGE IDLE TEMP
NEW IDLE
Figure 55
Down arrow button to run the table
D. Push the
all the way down.
E. Let the furnace sit at least two hours.
or water. (Do not use Fantastic
®
/ " Teflon
1
2
0C
651C
or 409 as
® ®