Whip Mix Pro Press 100 Operation Manual page 2

Pro Series Furnace Operations Manual
Warnings
DO NOT OPERATE THIS FURNACE WITH ANY
OTHER POWER CORD.
DO NOT OPERATE WITH AN EXTENSION CORD.
OPERATING THIS FURNACE ON A CIRCUIT WITH
OTHER FURNACES OR ELECTRICAL APPLIANCES
THAT REQUIRE SIGNIFICANT POWER MAY CAUSE
A CIRCUIT BREAKER TO TRIP.
Warranty
United States and Canada
Whip Mix Corporation warrants the Pro 100 and Pro
Press 100 to the original purchaser against defective
workmanship and materials under normal procedures of
installation, use and service within the dental profession,
for a period of three years or 3750 muffle hours, whichever
occurs first. During which time Whip Mix Corporation will
replace, repair or deny warranty coverage at its discretion.
Heat treating refractory materials, misuse, improper
installation, improper maintenance, accident or abuse
will void the warranty. Whip Mix coverage only applies to
Whip Mix supplied parts, and repairs performed by Whip
Mix certified repair technicians. Repairs performed during
the warranty period do not extend the warranty period.
Warranty coverage under these terms extends only to
furnaces produced or sold to the original purchaser after
12/31/04. Shipping damage is only covered from Whip
Mix to the intended recipient.
International
Two years parts and labor from date of purchase
from dealer.
Accessories
Pro Press 100
Manual
Cooling Tray
Firing Tray
Press Firing Tray
Power Cord
Temperature Calibration Certificate
Ceramic Insert
Press Air Regulator
Pro 100
Manual
Cooling Tray
Firing Tray
Power Cord
Temperature Calibration Certificate
2
WHEN OPERATING THE PRO 100, USE ONLY ARGON
GAS. ATTACHING ANY FLAMMABLE OR NOXIOUS
GAS IN THIS FURNACE COULD CAUSE EXPLOSION OR
PERSONAL INJURY!
Recommendations
Note: During shipping the muffle might absorb moisture
from the air. So, it is recommended you heat the muffle to
dry the moistur any porcelain. To dry the muffle, set the idle
temperature to 400° C for one hour and 600° C for one hour.
Follow the numbered instructions in this section to set the
ideal temperature to the temperatures mentioned above.
Whip Mix recommends leaving the furnace on at all times.
Turning the furnace off overnight may cause damage to
the muffle, contamination and void the warranty. Leaving
your furnace on will also extend the life of your furnace.
See Night Mode, page 10 for further information. Leaving
the furnace on will also extend the life of the battery on the
main board. If the furnace is off and the battery fails, all
software, calibrations and programs will be lost.
IMPORTANT: CONTACT YOUR
DEALER OR THE FACTORY FOR
COMPLETE INSTRUCTIONS ON
CONvERTING THE FURNACE
BETWEEN 115 vAC AND 220 vAC.