Step 8: Install Drain Hose To Drain Loop; Step 9: Position Water Line And House Wiring; Step 10: Install Drain Hose, Through Cabinet - GE Built-In Dishwasher Installation Instructions Manual

Dishwasher Installation
STEP 6: REMOVE FLOOR PROTECT
(on some models)
• Remove leak sensor (on some models). Remove screw from
leak sensor on the front of the Floor Protect with a 1/4" driver.
• Remove 2 screws .
• Rotate Floor Protect outward and lift out of the mounting tabs.
• Set aside for use in Step 22.
STEP 7: INSTALL 90° ELBOW
• Thread 90° elbow
onto the water valve.
• Do not overtighten
elbow. Water valve
bracket could
bend or water valve
fitting could break.
• Position the end of
the elbow to face the
rear of the dishwasher.
STEP 8: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
Figure N
NOTE: The high drain loop on the side of the tub is designed for
better wash performance. Do not remove from the side of the tub.
Leak Sensor
Floor Protect
Figure L
Front of dishwasher
Water Valve
Bracket
Figure M
STEP 9: POSITION WATER LINE
• Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Figure O
STEP 10: INSTALL DRAIN HOSE,
• Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate hole.
90° Elbow
Fill Hose
Insulation
Blanket
Figure P
or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.
AND HOUSE WIRING
4"
6"
Water House
Line
Wiring
THROUGH CABINET
Power Cord
(If Used)
4"
6"
Maximum Drain Hose
Length 15'
Water
Line
Drain
Hose
House
Wiring
7