Step 7: Install Drain Hose To Drain Loop; Step 8: Position Water Line And House Wiring; Step 9: Install Drain Hose, Through Cabinet - GE Built-In Dishwasher Installation Instructions Manual

Dishwasher Installation
STEP 5: IF NECESSARY, REMOVE FLOOR
PROTECT (on some models)
• Disconnect leak sensor wire
(on some models).
• Remove 2 screws from front of the
Floor Protect with a ¼" driver.
• Lower front of pan and slide out from
under dishwasher.
• Set aside for use in Step 21.
STEP 6: INSTALL 90° ELBOW
• Thread 90° elbow
onto the water valve.
Ensure rubber gasket
is located between
valve and elbow.
• Do not overtighten
elbow. Water valve
bracket could
bend or water valve
fitting could break.
• Position the end of
the elbow to face the
rear of the dishwasher.
STEP 7: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
Figure N
NOTE: The high drain loop on the side of the tub is designed for
better wash performance. Do not remove from the side of the tub.
Squeeze connector at top
to release snap feature
Leak Sensor
Floor Protect
Figure L
Front of dishwasher
Water Valve
Bracket
Figure M
STEP 8: POSITION WATER LINE
• Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Figure O
STEP 9: INSTALL DRAIN HOSE,
• Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate cabinet opening.
90° Elbow
Fill Hose
Ensure drain hose is not
twisted or pinched
Maximum drain hose
length is 15'
Do not disconnect or remove high
drain loop from left side of dishwasher
Figure P
or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.
AND HOUSE WIRING
4"
6"
Water House
Line Wiring
THROUGH CABINET
House
Wiring
Power Cord
(If used)
Drain
Hose
Water
Line
4"
6"
Insulation
Blanket
7