Page 1
Parts and Instruction Manual Lumina 20 Battery Burnisher...
Page 2
This manual is furnished with each new MINUTEMAN Lumina 20. This provides the necessary operat- ing and preventive maintenance instructions. Operators must read and understand this manual before operating or servicing this machine. This machine was designed to give you excellent performance and efficiency. For best results and minimal cost, please follow the general guidelines below: ·...
IMPORTANT SAFETY INSTRUCTIONS CAUTION: Operators must read and understand this manual before operating or maintaining this machine. Keep hands and feet clear of moving parts while machine is in operation. Disconnect the power to the machine by pressing the Red Emergency Disconnect Button when charging batteries or during installation or removal of pads.
Operating Instructions Inspection Carefully unpack and inspect your burnisher for shipping damage. Each unit is tested and thoroughly inspected before shipment; any damage is the responsibility of the delivery carrier who should be notified immediately. Electrical This machine is battery operated and designed to operate on 36 volts DC (3) 12 volt batteries. Batteries Burnishers are shipped with batteries.
Battery Service and Installation WARNING: Battery acid can cause burns. When working on or around batteries, wear protective clothing and safety glasses. Remove metal jewelry. Do not lay tools or metal objects on top of batteries. Charging of Batteries Charging batteries generates explosive gasses. DO NOT CHARGE BATTERIES WHEN OPEN FLAMES OR SPARKS ARE PRESENT.
Pad Installation The red emergency disconnect button and the key switch must be in the OFF position before installation and the pad driver assembly in the RAISED position. Remove center cup locking device by gripping on outer edges and turning clockwise. NOTE: Center cup cannot be pulled out; it must be unscrewed. After removing used pad, place new pad on pad driver assembly using outer flange of pad driver to center the pad.
ADJUSTMENT NUT 260528 LINK 260529 TRAILING LINK 260536 BASE PLATE WELDMENT 260576 LINK 260610 SHROUD ASS'Y, NEW - LUMINA 20 670605 ROLLER PIN 710307 SCR-MC 6-32 X 1.0 ST PL PAN HD 711350 NUT NYLOC 10-32 711380 NUT-NYLOC 3/8-16 NUT 711430...
Housing Assembly BOM BILL OF MATERIAL ITEM PART NO. REQ'D DESCRIPTION 260501 FIXED TOP COVER 260502 MOVING TOP COVER 260503 BAG COVER 260504 FILTER COVER WELDMENT 260560 HINGE 9.75" 260590 HOSE ASSY DUST CONTROL 260592 EXHAUST FILTER DUST CONTROL 260596 INSERT FITTING, 1-1/2"PVC, FPT 310008 O RING BUNA 2201510561...
Pad Driver Assembly BOM BILL OF MATERIAL - 260610 ITEM PART NO. REQ'D DESCRIPTION 260573 MOTOR GRILL ASSY 260597 KEY, 3/16 X .906 260611 PAD DRIVER SHROUD - 20" 260615 MOTOR PLATE WELDMENT - NEW 260616 DUST SKIRT - NEW 260619 PAD DRIVER STRAP 670075...
Pressure Control Assembly BILL OF MATERIAL - 260549 ITEM PART NO. REQ'D DESCRIPTION 260066 OILITE BUSHING 260547 PRESS ADJ MOUNT WELD 260554 PRESS ADJ SCREW 260557 PRESS ADJ SLIDE 260562 PRESS ADJ RET BRKT 260563 PRESS ADJ RET BRKT 260564 ROLL PIN 3/16"X3/4"...
A potential health hazard exits without original equipment replacement. All warranted items become the sole property of Minuteman or its original manufacturer, whichever the case may be. Minuteman disclaims any implied warranty, including the warranty of merchantability and the warranty of fitness for a particular purpose.