Table of Contents IMPORTANT SAFETY INSTRUCTIONS ................4 OPERATING INSTRUCTIONS ................... 5 INSPECTION ........................5 ELECTRICAL ........................5 BATTERIES ........................5 OPERATION ........................5 AFTER USE ........................6 MAINTENANCE ......................6 FLOOR SEAL STRIP ...................... 6 BATTERY SERVICE AND INSTALLATION ..............6 CHARGING OF BATTERIES ..................
IMPORTANT SAFETY INSTRUCTIONS CAUTION: Operators must read and understand this manual before operating or maintaining this machine. Keep hands and feet clear of moving parts while machine is in operation. Disconnect the power to the machine by pressing the Red Emergency Disconnect Button when charging batteries or during installation or removal of pads.
OPERATING INSTRUCTIONS INSPECTION Carefully unpack and inspect your burnisher for shipping damage. Each unit is tested and thoroughly inspected before shipment; any damage is the responsibility of the delivery carrier who should be notified immediately. ELECTRICAL This machine is battery operated and designed to operate on 36 volts DC (3) 12 volt batteries.
AFTER USE To raise the pad driver, push down until the pedal arm engages into the pedal catch. Turn machine off by turning the key switch on the control panel. Machine can be cleaned with a mild detergent and a damp cloth. Batteries should be charged after each use or when the battery condition meter shows a low charge.
PAD INSTALLATION The red emergency disconnect button and the key switch must be in the OFF position before installation and the pad driver assembly in the RAISED position. Remove center cup locking device by gripping on outer edges and turning clockwise. NOTE: Center cup cannot be pulled out;...
CIRCUIT BREAKER PROTECTION 70 amp circuit breaker protects pad driver motor from excessive overload conditions. 30 amp circuit breaker protects control circuits against possible electrical shorts. If either circuit breaker trips, first determine the cause and correct the condition before resetting the breakers.
DASHBOARD CONTROL PANEL ON / OFF KEY SWITCH TRACTION DRIVE DIRECTION INDICATOR TRACTION DRIVE DIRECTIONAL SWITCH PAD PRESSURE GAUGE TRACTION DRIVE SPEED CONTROL BATTERY GAUGE...
HOUSING ASSEMBLY BOM ITEM # PART # QTY DESCRIPTION 260501 FIXED TOP COVER 260502 MOVING TOP COVER 260503 BAG COVER 260504 FILTER COVER WELDMENT 260560 HINGE 9.75" 260590 HOSE ASSY DUST CONTROL 260592 EXHAUST FILTER DUST CONTROL 260596 INSERT FITTING, 1-1/2"PVC, FPT 310008 O RING BUNA 2201510561 320246...
PAD DRIVER ASSEMBLY BOM ITEM # PART # QTY DESCRIPTION 260573 MOTOR GRILL ASSY 260611 PAD DRIVER SHROUD - 20" 260615 MOTOR PLATE WELDMENT - NEW 260616 DUST SKIRT - NEW 260617 CLAMP BAND ASSY FOR 20" HS 670075 PAD DRIVER ASSY 710857 SCR-SC 5/16-24 X 1.00 711124...
SCR-MC 10-32 X .37 ST 711391 NUT-HEX JAM 3/8-16 ST 712536 SCR-MC 10-24 X .62 TH 715038 DECAL, PAD PRESSURE 715634 DECAL, MINUTEMAN ID 760034 KNOB, ADJ (SET SCREW) 762253 CABLE, ASSY PRESSURE 833102 SPRING, .62 X .75 X 1...
In addition, Minuteman International, Inc. will, at its option, honor labor warranty claims for the first 12 months from date of sale, provided such claims are submitted through and approved by factory authorized repair stations.