HAMPTON BAY GC60 Owner's Manual page 13

Freestanding cast iron pellet stove
Hide thumbs Also See for GC60:
Table of Contents

Advertisement

Routine Cleaning and Maintenance
EXHAUST PASSAGES (Biannually)
1. Open the firebox door by lifting
the handle.
2. Remove the burn pot assembly
and clean all the parts.
3. Lubricate
penetrating oil.
4. Lift the baffle, remove the firebox
liner, and lift out the firebox
lower. Vacuum the firebox and
firebox liner thoroughly.
5. Open the ash box door; remove
the ash box and cleanout the
cavity.
6. Re-install the ash box, firebox
lower, baffle, firebox liner, burn
pot, and burn pot liner
7. Close the firebox and ash pan
doors and secure.
BLOWER MECHANISMS (Annually)
Unplug the stove then open the right and left side panels to access the two blowers. Remove the T-20
torx Screws located on the top and bottom of the rear access panels.. Vacuum all dust from motors. The
blower motors has sealed bearings, DO NOT lubricate this motor. Check gaskets and replace if needed.
poSt SeaSon cLean-up
Once you are finished using the pellet appliance for the season, unplug the stove for added electrical
protection. It is very important that the stove be cleaned and serviced as stated above.
CLEANING PAINTED SURFACES
Please clean surfaces with a soft damp cloth.
CLEANING ENAMEL SURFACES
Enamel Finishes and painted surfaces can be wiped down with a soft damp cloth. Wd/40 oil can be
used to clean enameled casting if necessary.
FIREBOX LINER
The paint on the Firebox Liner may peel. This is due to extreme conditions applied to the paint and is in
no way covered by warranty.
DOOR GLASS REPLACEMENT
It is recommended that your dealer replace the glass if broken. The door glass is made of high temperature
PYRO CERAMIC and must be purchased through your dealer. To replace the glass, unscrew and remove
the six (6) retainer nuts using a
fiberglass tape should be used around the glass in the same location as the original fiberglass. Insert
the glass into the retainer, screw the door to the retainer, and gently tighten nuts. Ensure that edge
clearances are maintained. The use of substitute materials is prohibited: #50-2119.
Hampton GC60 Cast Pellet Stove Owner's Manual
all
screws
with
5
/
" socket. Remove the glass and any broken pieces. High temperature
16
Firebox Baffle
Firebox Liner
Firebox Lower
figure 10: Gc60 exhaust passages.
Ashpan
Burner System
13

Advertisement

Table of Contents
loading

Table of Contents