GE DPVH880EJ Technical Service Manual page 22

9. Stand the washer or dryer upright. Move it close
to its fi nal location.
10. Make sure that the washer or dryer is level by
placing a spirit level on top. Check side to side
and front to back.
11. Use an open ended or adjustable wrench to
adjust the legs in and out. Tighten the locknuts
against the bottom of the pedestal.
Note: To minimize vibration, the locking nuts must
be tight.
12. Check to be sure the slides are closed.
13. Slide the drawer into the opening. Align the
drawer supports to the slides on each side.
14. Reinstall the original screws into each drawer
slide. Tighten both screws.
15. Open the drawer fully. Slide drawer divider into
slots in the center of the drawer. The drawer
should slide smoothly when you push it closed.
16. Remove the 4 shipping screws on the back side
of the washer.
Note: Refer to the dryer Installation instructions
(Pub# 49-90341) to complete the installation.
– 22 –