GE DPVH880EJ Technical Service Manual page 21

3. Pull the drawer out as far as it will go.
4. Remove screws from drawer slides. Slide drawer
out of the base and set aside.
Note: The support pads should be installed on the
dryer only. DO NOT INSTALL THESE PADS ON THE
WASHER PEDESTAL.
5. Locate the 4 support pads from the parts
package. Each pad has 2 protrusions that fi t
into the holes on top of the pedestal. Press the
rubber pads into each set of corner holes on the
top of the pedestal as shown.
6. Place the pedestal against the bottom of the
washer or dryer. Check to be sure the drawer
front is at the front of the washer or dryer.
7. Align the holes in the pedestal with the holes in
the bottom of the washer or dryer. Use a Phillips
screwdriver to install the 4 bolts through the
pedestal and into the washer or dryer―do not
tighten.
8. Slide the pedestal toward the washer or dryer,
until it is aligned front to back. Use an 8-mm
socket wrench to securely tighten the bolts.
– 21 –
(Continued Next Page)