Power Board - GE DPVH880EJ Technical Service Manual
Profile dryer
Hide thumbs
Also See for DPVH880EJ:
- Dimensions and installation information (4 pages) ,
- Owner's manual & installation instructions (152 pages) ,
- Dimension manual (4 pages)
Table of Contents
Advertisement
Power Board
The power board is mounted in a plastic housing
that is attached to a bracket located under the top
panel.
To remove the power board:
1.
Remove the control and top panels. (See
Control
and
.)
Panel
Top Panel
2.
Mark and
disconnect the wire harnesses and the
ground wire from the dryer to the power board
assembly.
3. Remove the 2 Phillips-head screws that attach
the power board to the power board support.
Note: If replacing the power board, transfer the
model selector harness to the replacement power
board in the same location as on the original.
Model Selector Harness
Control Board Assembly
The control board assembly is mounted in a plastic
housing that is attached to the inside of the control
panel. It consists of 3 circuit boards connected by
ribbons. The boards and the plastic housing are
replaced as an assembly.
Operation of the control board assembly can be
checked by using the service test mode. (See
Service
.)
Test Mode
Error codes that are specifi c to the control board
can initiate error codes E1 and E18. (See S
ervice Test
.)
Mode
To remove the control board assembly:
Caution: To avoid marring the control panel, place
the panel face down on a protective surface.
1.
Remove the control and top panels. (See
C
ontrol
and
.)
Panel
Top Panel
2.
Remove the 5 Phillips-head screws that attach
the control board plastic housing to the control
panel. Remove the housing.
3. Remove the 26 Phillips-head screws that attach
the control board assembly to the plastic
housing.
4. Remove the wire harness from connection J1.
Page 54
- Quick Links:
- Drive Belt
- Troubleshooting
- Service Test Mode
Hide quick links:
Advertisement
Table of Contents
