GE DPVH880EJ Technical Service Manual page 18

12. Assemble the new right-side door cap (from
reversibility kit), using 2 (#8 x 0.625-in.) tapping
screws.
Screws
Door cap
13. Put the chrome cover aside on a soft, protected,
fl at surface.
14. Lay the inner door down on a soft, protected,
fl at surface so the inner part faces up.
15. Remove the 2 plug buttons on the opposite side
of the hinge, using a putty knife or thin-blade
screwdriver.
16. Disassemble the inner door cap from the inner
door by removing 2 (#8 x 0.75-in.) tapping
screws.
17. Disassemble the hinge from the inner door by
removing 4 (#8-32 x 0.50-in.) machine screws.
Remove
4 screws
Hinge
Inner door
cap
2 plug
2 screws
buttons
18. Assemble the hinge to the opposite side of the
inner door, using 4 (#8-32 x 0.50-in.) machine
screws.
19. Assemble the new inner door cap (from
reversibility kit) on the opposite side of the hinge,
using 2 (#8 x 0.75-in.) tapping screws.
20. Install the 2 plug buttons on the opposite side of
the hinge in the 2 remaining holes.
Replace
2 screws
Inner
door cap
21. Turn the inner door over and place on a soft,
protected, fl at surface so that the inner part is
facing down.
– 18 –
Replace
Replace
4 screws
2 plug
buttons
(Continued Next Page)
Hinge