Installing WLAN module
►
Open the casing (see "Opening the casing").
►
Remove the front (see "Removing the front panel").
►
Detach the USB data cable and, if present, the audio data cable from the mainboard (see the
manual for the mainboard).
►
Pull the cables from the floppy disk drive.
►
Remove the floppy disk drive (see "Removing the floppy disk drive" - "Installing and removing
drives").
2
►
Slide the WLAN module into the slide-in module (1).
►
Fasten the WLAN module with the screws (2) on both sides of the slide-in module.
►
Insert the blind cover into the slide-in module bezel from the inside.
A26361-K665-Z126-1-19, edition 1
System expansions
2
67